Connect an ADMS device
Many ZKTeco devices (uFace, SpeedFace, MB, K and iClock series and others with "ADMS" or "Cloud Server" in the menu) can push punches straight to AR ADMS Cloud over the internet.
1. Register the device in the panel
- Open Devices → Add device and choose ADMS (direct to cloud).
- Enter the serial number exactly as the device shows it under Menu → System Info → Device Info, choose the branch and save.
Only registered serial numbers are accepted, so nobody else's device can send data into your account.
2. Point the device to the cloud
- On the device open Menu → Comm. → Cloud Server Setting (on some models ADMS or Network → Cloud Server).
- Server address:
adms.artoolshub.com - Server port:
80 - Turn off HTTPS, Domain name and Proxy server, then save.
- Make sure the device has internet access: correct IP, gateway and DNS under Comm. → Ethernet.
Within about a minute the device page in the panel shows Online. Punches already stored on the device are uploaded too, so nothing from before the setup is lost.
3. Check the time
Set the device clock and time zone correctly (Menu → System → Date/Time). The cloud stores each punch in UTC and shows it in your organization's time zone; if a device clock drifts, the attendance record is flagged for review.
Troubleshooting
| Stays offline | Check the server address and port, that HTTPS and Domain name are off, and that the device can reach the internet (try another network cable or the router's DHCP). |
|---|---|
| "Unregistered device" | The serial number in the panel does not match the device. Compare it character by character. |
| Punches but no names | The device user IDs are not linked yet. On Employees, open Unmapped device IDs and link them, or create the employees with the same device user ID. |
| No "Cloud Server" menu | The device has no ADMS. Use the Windows Collector instead. |